The use of ceramic waste, originated from construction sites and industries, as fine and coarse aggregate in concrete presents an effective and sustainable endeavor to environmental problems through the reduction in the degradation of natural resources caused by extraction of natural aggregates and decrease in dumping volume as well.

The sources of ceramic waste are obtained from the industrial in Malaysia. Presently, in ceramics industries the production goes as waste, which is not under going the recycle process yet. The potential of recycled …

The study focuses on analyzing the compressive strength in usage of ceramic waste material as partial replacement of coarse aggregates. Concrete cubes were prepared for 5, 10, 15, 20 and 25% replacements and tested for optimum content for two grades of concrete mixes...

The employment of waste ceramic as a fine and coarse aggregate replacement was studied in this current research. Specimens with ceramic waste as fine and coarse aggregates at varying percentage levels of 0%, 10%, 20%, 30%, 40%, and 50% was prepared for the current study.

Thus to achieve the goal of sustainable construction utilization of waste material in concrete is very much helpful. So, this study intends to use of waste ceramic tile aggregates as an alternative material of coarse aggregates in concrete production.

A coarse aggregate replacement scheme in concrete is investigated with three different waste ceramic tile materials in replacement ratios including 20%, 25%, 35%, 50%, 65%, 75%, 80% and .

Hence, the crushed waste ceramic tiles were used in concrete as a replacement for natural coarse aggregates with 0%, 5%, 10%, 15% 20% and 25% of substitution. After analyzing results, the optimum value of waste ceramic tile to be used within the concrete mix with a water/cement ratio of 0.5 was determined as about 20%.

Due to its physical, chemical and mechanical properties, the waste inevitably generated by the ceramic sanitary ware industry can be used in the production of concrete. This article reports the possibility of substituting 15%, 20% and 25% of natural coarse aggregate with recycled ceramic coarse aggregate, and presents an analysis of the …

Abstract. The sanitary ceramics industry inevitably generates wastes, irrespective of the improvements introduced in manufacturing processes. The present study investigated the reuse of these wastes as recycled coarse aggregate in partial substitution (15%, 20% and 25%) of natural coarse aggregates in the manufacture of structural …

The results show that the concretes made using ceramic sanitary ware aggregate possessed the same mechanical properties as those made with conventional aggregate. It is therefore possible to conclude that the reuse of recycled ceramic aggregate to produce recycled concrete is a feasible alternative for the sustainable management of this waste.

This study therefore focused on structural effect of the partial inclusion of Ceramic Tile Waste (CTW) as coarse aggregates in the concrete production.

Thus, the current study focuses on the mechanical characterization of waste ceramic wall and floor tiles aggregate concrete. Ceramic wastes sourced from construction and demolition wastes were separated from other debris and crushed using a quarry metal hammer. Ceramic tiles were sieved into fine and coarse aggregates in line with …

The objective of this investigation is to study and evaluation of the effects of the recycled ceramic as fine, coarse aggregate and ceramic fume as replacement for conventional material on the ...

The potential of recycled ceramic waste as a substitute for coarse aggregates in concrete has been investigated. Three types of ceramic waste, namely tiles, clay brick and flowerpot were used.

Abstract. The manufacture of any kind of product inevitably entails the production of waste. The quantity of waste generated by the ceramic industry, a very important sector in …

The reuse of ceramic waste as a substitute for coarse aggregate in concrete has been investigated. The ceramic wastes are of three types, namely Tiles, Clay bricks and flowerpot were used. This study intends to use of ceramic tile aggregate in concrete production. Ceramic tiles were obtained from manufacturing industries, from …

The decrease in density and strength was due to ceramic waste being lighter and more porous than normal coarse aggregate. Tensile strength of concrete with ceramic waste decline gradually from 8.39 N/mm2 to 6.13 N/mm2 for the control and 75% replacement samples respectively.

In this investigation, ceramic waste aggregate is used in place of natural coarse aggregate in proportions of 0%, 20%, 40%, 60%, 80% and .

Waste ceramic materials can become a cheaper but almost equivalent alternative to fly ash, metakaolin or ground granular blast furnace, and other supplementary binder materials used in concrete...

Ceramic waste can be transformed into useful coarse aggregate. The properties of ceramic waste coarse aggregate are well within the range of the values of concrete-making aggregates. The compressive, splitting tensile and flexural strengths of ceramic waste coarse aggregate concrete are lower by 3.8, 18.2 and 6%. …

Coarse aggregate replacement with clean ceramic floor tile, clean ceramic wall tile, and actual waste ceramic tile are the primary focuses for this paper. A total of …

Ceramic Waste partially replaced as a substitute for coarse aggregates in concrete has been investigated. Two types of ceramic waste, namely tiles and flowerpot …

Semantic Scholar extracted view of "Impact of waste ceramic tiles as partial replacement of fine and coarse aggregate in concrete" by A. Sivakumar et al.

The waste ceramic was used as a replacement for coarse aggregates in concrete. The results indicated that the use of waste ceramic increased the flexural, split …

In this experimental investigation, the concrete mix cast using ceramic waste as replacement to coarse aggregates partially by 0%, 10%, 20 % and 30%.C…

The use of porcelain ceramic waste can be, therefore, recommended as replacement for conventional coarse aggregate in concrete not only because it increases concrete compressive strength but also because the dumping of waste porcelain tiles in the environment can thus be avoided.

The utilisation of solid waste in concrete has piqued the imagination of indefinite investigators experimenting with waste material as aggregate substitute. The substitute for coarse aggregate is ceramic tile waste in concrete, which had improved mechanical, physical and longevity properties.

The decrease in density and strength was due to ceramic waste being lighter and more porous than normal coarse aggregate. Tensile strength of concrete with ceramic waste decline gradually from 8.39 N/mm 2 to 6.13 N/mm 2 for the control and 75% replacement samples respectively.

This research looked at varying percentages of natural coarse aggregate partially substituted with Coarse Ceramic Aggregate (CCA) in the same mixture design …

Download Citation | On Apr 30, 2018, Vivek Singh published To Study the use of Ceramic Waste as Partial Replacement of Coarse Aggregate on the Concrete - A Review | Find, read and cite all the ...